Samsung WF365BTB series - Page 13

Removal and Reassembly _ 11
Part Figure Description
Separating the
Heater at the Bottom
Front
(option: This section is
applied to the WF220*
models.)
1. DisassembletheFront-Frame.
2. Separatetheconnectionwire
- SeparatetheThermostatxedatthebottomof
theTub.(Takeprecautionastheremaybewater
remaining.)
 MakesuretoseparatetheThermostatrstand
thenseparatetheHeater.Ifyoufailtoobserve
this order, it may result in a shock and be
damaged.
3. ReleasethenutholdingtheHeaterwithanM10
toolandthenseparatetheHeater.
 Donotcompletelyreleasethenut.
PulltheHeaterforwardafterreleasingthenut.If
theHeaterisdamaged,itmaycauseaproblem.
Therefore unfasten the nut using spanner
or wrench manually without using pincers or
tweezers.
When you re-assembly the heater, make sure to
install the heater exactly onto the Bracket inside
theTub.Ifitisnotproperlyinstalled,itmay
causeare.Inaddition,completelyinsertthe
packing part into the Tub when assembling it so
that the packing part is completely attached onto
theTub.
4 Check Points for Troubleshooting
1. CheckiftheresistanceoftheHeaterisequalto27.1Ω(forthe1900Wproduct),or26.2Ω
(forthe2000Wproduct).
2. CheckiftheresistanceoftheThermistorisequalto12kΩ(atroomtemperature).