Samsung WF365BTB series - Page 18

16 _ Removal and Reassembly
Part Figure Description
Disassembling and
Repairing the Water
Supply Valve
1. SeparatetheCOVER-TOPandthenseparate
thewireconnectedtothevalves.
2. Removethe4screwsxingthevalves.
3. Removethehoseconnectedtothevalves.
(Use the plier to remove the hose)
Disassembling and
Repairing the Water
Level Sensor.
1. SeparatethewireconnectedtheSENSOR-
PRESSURE.
2. Adjusttheplasticclip(ofpressuresensor)
between two nose of plier, then grip and pull the
plastic clip with caution(Use the long nose plier
topushthehook).
3. RemovethehosefromtheSENSOR-
PRESSURE.
4 Check Points for Troubleshooting
• Checktheresistancewithatester.
Disassembling the
inside Detergent Box
• HoldtheClampoftheDetergentBoxand
disassembletheHose-Drawer-Tub.
Use the long nose