Samsung WF42H5700A Series - Installation Flow Chart; Shipping Bolt Removal and Location Selection

ALIGNMENT AND ADJUSTMENTS
15
Smart Install Mode
Denition of Smart Install Mode:
- SmartInstallModeisthemodethatconrmwhether
normalsetmodeendsaftersettinghasbeendone.
How to Enter:
- Understandbycondition,Settheappointmenttime
to17:00.IfyoupushStart/Pausebuttonfor7seconds,
youwillenterSmartInstallMode.
Samrt Install Mode
- WhenenteringSmartInstallMode,itwilldisplay“SC”.
- SmartInstallModehastwoModes
ManualMode:WhenyoupushDelayEndbutton,
submodewillbeadded.
AutomaticMode:Undertheconditionof“SC”or“OK”
beingdisplayed,ifyoupushStart/Pausebutton,itwillchangetoautomatic
modetilltheendofinspection.
- ThedisplayandTestofvarioussubmodesareasfollows:
SC:standbycodition
1:DoorLockTest
2:DrainPumpTest1
3:PreValveTest
Co:ColdValveTest
Ho:HotValveTest
6:WatershotValve&MotorTumble&WaterHeaterTest
7:DrainPumpTest2
8:SpinTest
9:DryHeater&DryFanTest
10:DoorUnlockTest
Ot(OK):Normalend
- Ifyoupush“DelayEnd+Start”simultaneouslywhendisplaying”SC”,EEPROMwillbereadand
OKornGwilldisplay.
- Ot(OK):SmartInstallendsnormally.
nG:SmartInstallendsabnormallyordoesn’texecute.
Standby Condition
Set the appointment time to 17:00
Push Start/Pause button for
7 seconds
Smart Install Mode
Toavoidriskofelectricalshock,personalinjuryordeath;disconnectpowertowasher
beforeservicing,unlesstestingrequirespower.
WARNING
(Techsheet)WF42H5-03387A_EN.indd 15 2013-12-24 17:12:49