Samsung WF45K6500AV/A2 - Installation and Setup; Installation Requirements and Procedures

12 _ Removal and Reassembly
Part Figure Description
Separating the
Cover_Top and
Panel-Control
(Check Sub-PCB)
1. Removethe2hexagonscrews,whichareatthe
back,xingtheCOVER-TOP.
2. DisassembletheCOVER-TOPbyslidingit
backwards.
3. PresstheSeparatebuttontoseparatetheASSY
DRAWER.
4. PullthePANEL-CONTROLtowardsandthenliftit
upwardstoseparate.
5. Carefullydisconnectthetwowiringconnectorsby
hand.
6. DisassembletheASSYKNOB-ENKODERby
pullingitupwards.
7. RemovetheallscrewsholdingthePCBand
releasethehooksonbothsidestoremovethe
PCBforrepair/replacement.