Samsung WF45N5300AV - Standard Disassembly Drawings

10 _ Removal and Reassembly
3-2. STANDARD DISASSEMBLY DRAWINGS
► Thisisastandarddisassemblydiagramandmaydifferfromtheactualproduct.
Usethismaterialasareferencewhendisassemblingandreassemblingtheproduct.
Part Figure Description
Disassembling and
Repairing the Rear
Motor
1. Removethe2screwsholdingtheBack-Coverat
thebackofthewashingmachineandseparatethe
Back-Coverpushingitdownwards.(Assembleitby
liftingitupwards)
2. AfterseparatingtheBack-Cover,removetheM19
nutholdingtheMotor.Toremoveit,turnitcounter-
clockwise.AstheMotoralsorotatesifthenutis
turnedslowly,torqueitquicklyandrmlyinasingle
action.
 Donotremovethenutbyinsertingascrewdriver
intotheMotor,asthismayresultinaproblemwith
themotor.
3. RemovetheM19nutandwasherandthen
separatetheRotor.Sinceremovingtherotor
requiresalotofstrengthduetothemagneticforce
oftheRotoranditmaycomeo󰀨suddenly,your
handorarmmaybeinjuredbytheedgeofthe
StatororFrame.Thereforetakeprecautionwhen
separating it.
 Youcanseparatetheconnectorbypressing
Motorwire
Hallsensor
4. SeparatetheMotorWireandHallSensorwhile
pressingthenaveloftheHousing.Takeprecaution
whenyoudothisbecausetheHallSensorpartis
easilyshocked.
5. Separatethe6M10screws.→SeparatetheAssy
BracketMotor→SeparatetheStator.
 Whenremovingthelastofthe6screws,holdthe
Statorasitmayfallwhenthescrewsareremoved.
* Check Points for Troubleshooting
1. CheckifthereisanyaliensubstancebetweentheRotorandtheStator.
2. Checkifthemotorpower(Blue,White,Red)wireisconnected.
3. CheckiftheHallSensorwireisconnected.
 TheorderofthemotorwiresisBlue,White,andRedfromtheright.Checkifthe
resistancebetweenBlue-White,White-Red,andRed-Blueisequalto15Ω.