EasyManua.ls Logo

Samsung WF520AB Series - Water Supply and Drain Setup; Flooring, Clearances, and Installation Steps

Samsung WF520AB Series
47 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12 _ Removal and Reassembly
3-2. STANDARD DISASSEMBLY DRAWINGS
► Thisisastandarddisassemblydiagramandmaydifferfromtheactualproduct.
Usethismaterialasareferencewhendisassemblingandreassemblingtheproduct.
Part Figure Description
Disassembling and
Repairing the Rear
Motor
1. Removethe2screwsholdingtheBack-Coverat
thebackofthewashingmachineandseparatethe
Back-Coverpushingitdownwards(Assembleitby
liftingitupwards)
2. AfterseparatingtheBack-Cover,removetheM19
nutholdingtheMotor.
Toremoveit,turnitcounter-clockwise.Asthe
Motoralsorotatesifthenutisturnedslowly,torque
itquicklyandrmlyinasingleaction.
Donotremovethenutbyinsertingascrewdriver
intotheMotor,asthismayresultinaproblemwith
themotor.
3. RemovetheM19nutandwasherandthen
separatetheRotor.
Sinceremovingtherotorrequiresalotofstrength
duetothemagneticforceoftheRotorandit
maycomeoffsuddenly,yourhandorarmmay
beinjuredbytheedgeoftheStatororFrame.
Thereforetakeprecautionwhenseparatingit.
Youcanseparatetheconnectorbypressingthe
naveloftheHousingandpullingitoutside.
Motorwire
Hallsensor
4. SeparatetheMotorWireandHallSensorwhile
pressingthenaveloftheHousing.
TakeprecautionwhenyoudothisbecausetheHall
Sensorpartiseasilyshocked.
5. Separatethe6M10screws.→SeparatetheAssy
BracketMotor→SeparatetheStator.
Whenremovingthelastofthe6screws,holdthe
Statorasitmayfallwhenthescrewsareremoved.
4 CheckPointsforTroubleshooting
1. CheckifthereisanyaliensubstancebetweentheRotorandtheStator.
2. Checkifthemotorpower(Blue,White,Red)wireisconnected.
3. CheckiftheHallSensorwireisconnected.
TheorderofthemotorwiresisBlue,White,andRedfromtheright.Checkifthe
resistancebetweenBlue-White,White-Red,andRed-Blueisequalto15Ω.

Other manuals for Samsung WF520AB Series

Related product manuals