EasyManua.ls Logo

Samsung WF520AB Series - Dispenser, Filter, and Seal Maintenance; Storage and Drum Cleaning

Samsung WF520AB Series
47 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Troubleshooting _ 27
4-2. CORRECTIVE ACTIONS FOR EACH ERROR CODE
► Thesearecommontroubleshootingproceduresforeachdrum-typewashererrormode.Fordetailedinformation,refertothegeneralrepairscripts.
Error Type
Error Mode
Causes Corrective Actions Description of Photo
LED LCD
WaterLevel
Sensor
LE1
W a ter Level Sensor Problem
ERROR!
• Waterlevelsensorfault
• Incorrectconnectionsof
thewaterlevelsensor
terminal
• Thehosepartforthe
waterlevelsensoris
folded.
• MainPCBfault
• Checkthewaterlevelsensorterminal
connectionsandcontacts.
• Anerroroccursifanincorrectwater
levelsensorisused.Makesureto
checkthematerialcode.(Abnormal
operation)
• Ifthewaterlevelsensorisfaulty,
replaceit.
• Iftheerrorpersistsdespitetakingthe
actionabove,replacethePBA.
Checkthewaterlevelsensor
frequency.
- Checkitafterthewaterlevel
sensorandtheconnectorare
connected.
CheckingPart:PinkColor
WireOragneColorWire
- Frequency:Approx.26.4KHz
withnoload
WashingMotor
ErrorandHall
Sensor Error
3E
E3
bE
The Motor is not working
properly.
ERROR!
• Washingmotorfault
• Washingmotorhall
sensorfault
• Incorrectconnectionsof
thewashingmotor/hall
sensor connector
• Washingmotorrotorand
statorfault
• MainPCBfault
• Checkthemotorconnectorterminal
connectionsandcontacts.
• 3Eisdisplayedbecauseoverloading
occursduetotoomuchlaundry.
• Ifthehallsensorterminalisfaulty,
replacethehallsensor.
• Checkwhetherthestatorofthemotor
coverisdamaged.
• Checkforcoildisconnectionsdueto
foreignmaterial.
• IfthePBAcontrolcircuitisfaulty,
replacethePBA.
► CheckthemotorWinding
Coil
Plugouttheconnectorandread
resistancesatanytwoofthe
threeterminalsonMotor
:Shouldbe6.0Ω(at25°C)
► CheckthemotorHallSensor
Checktheresistanceonthe
main PCB motor
(Betweenpins1and3,and1
and4ofthefour(4)pins)
- Resistance
:Approx.2to4MΩ
- Checkthevoltagewhenthe
powerison.

Other manuals for Samsung WF520AB Series

Related product manuals