Samsung WW8*J6 Series

Questions and Answers:

D
dorothybrownSep 12, 2025
Why does my Samsung WW8*J6 keep stopping?
- N
  nelsoncaseySep 12, 2025
  If your Samsung Washer stops during operation, ensure the power cord is plugged into a live electrical outlet. Check the fuse or reset the circuit breaker. Make sure the door is closed and press the Start/Pause button. Note that clicking noises and a quick drain occur before filling. There may be a pause or soak period in the cycle. Clean the mesh filter of the water supply hose. Insufficient power can temporarily halt operation; it will resume when power is restored.
M
Mr. Michael JordanAug 22, 2025
What to do if my Samsung WW8*J6 Washer does not drain and/or spin?
- B
  bvalentineAug 22, 2025
  If your Samsung Washer isn't draining or spinning, ensure the drain hose is straight. Check for drain restrictions. Make sure the debris filter isn't clogged. Close the door and press Start/Pause. Also, verify the drain hose isn't frozen or clogged and is connected to an unobstructed drain system. Insufficient power can also cause temporary draining or spinning issues; the washer will resume normal operation once sufficient power is restored.
J
Jonathan BurnettAug 25, 2025
What to do if the door of my Samsung Washer does not open?
- A
  Amanda WellsAug 25, 2025
  If your Samsung Washer door won't open, press Start/Pause to stop the washer. Wait a few moments for the door lock to disengage, as it may take up to 3 minutes after the washer stops or power is turned off. Make sure all water is drained from the drum. The door lock light should be off once drained.
A
Andrea CookAug 26, 2025
Why is my Samsung Washer leaking water?
- C
  Chelsey CrossAug 27, 2025
  If your Samsung Washer is leaking water, ensure the door is properly closed and all hose connections are tight. Make sure the end of the drain hose is correctly inserted and secured to the drain system. Avoid overloading the washer and use high-efficiency (HE) detergent to prevent oversudsing.
D
David SalazarAug 27, 2025
Why is the water supply insufficient in my Samsung WW8*J6?
- J
  Jonathan JonesAug 27, 2025
  To resolve insufficient water supply issues with your Samsung Washer, fully open the water tap. Ensure the door is properly closed and the water supply hose isn't frozen, kinked, or clogged. Also, check for sufficient water pressure.
S
Susan RamirezAug 29, 2025
Why is the load still wet after a Samsung WW8*J6 cycle?
- J
  jriveraAug 30, 2025
  To address the issue of a wet load after a cycle in your Samsung Washer, use the High or Extra High spin speed. Use high-efficiency (HE) detergent to reduce oversudsing. Be aware that small loads may become unbalanced and not spin completely. Also, ensure the drain hose is not kinked or clogged.
M
Mark AguilarSep 18, 2025
What to do if the water level sensor is not working properly on my Samsung Washer?
- A
  Alexander SinghSep 18, 2025
  To troubleshoot the Water Level sensor on your Samsung Washer, try powering off and restarting the cycle. Check the Water Level Sensor wire harness. If the information code persists, contact a customer service centre.
A
Aaron WilliamsSep 13, 2025
Why is the Wi-Fi not working on my Samsung Washer?
- M
  Michael HobbsSep 13, 2025
  To address the issue of your Samsung Washer Wi-Fi not working, ensure your home internet connection is properly established. Make sure the router is turned on and operating normally. Also, verify that you have installed the latest version of the Smart Control App.
T
Tommy BrownSep 9, 2025
Why can't I add more detergent to my Samsung WW8*J6?
- J
  Jonathan BrownSep 10, 2025
  If you cannot apply additional detergent to your Samsung Washer, ensure the remaining amount of detergent and fabric softener is not over the limit. Also, verify that the Auto Dispense function is activated, with both the Water Hardness and Concentration settings specified correctly (applicable models only).
C
cstephensonSep 6, 2025
Why is my Samsung Washer vibrating so much and making noise?
- R
  Robert RushSep 6, 2025
  To address excessive vibrations or noise from your Samsung Washer, ensure it's on a level, solid floor. Adjust the leveling feet if needed. Remove the shipping bolts. Make sure the washer isn't touching anything. Balance the laundry load. Note that the motor and metal objects can cause normal operational noises; remove any such objects from the drum or filter case after washing.

Samsung WW8*J6 Series Specifications

General

Washing Capacity	8 kg
AddWash	Yes
EcoBubble Technology	Yes
Smart Control	Yes
Digital Inverter Motor	Yes
Quick Wash	Yes
Delay Start	Yes
Child Lock	Yes
Color	White
Energy Efficiency Class	A+++
Dimensions (HxWxD)	85 x 60 x 55 cm