STEP 4 - Connect the water hose
Connect the water supply hose to the water tap.
1. Remove the adaptor (A) from the water supply hose (B).
2. Use a Philips screwdriver to loosen four screws on the adaptor.
3. Hold the adaptor and turn part (C) in the arrow direction to loosen it
by 5 mm (*).
4. Insert the adaptor into the water tap, and tighten the screws while
lifting up the adaptor.
5. Turn part (C) in the arrow direction to tighten it.
6. While holding down part (E), connect the water supply hose to the
adaptor. Then, release part (E). The hose fits into the adaptor with a
clicking sound.
To Next Page
Loading...
