Aqua hose (applicable models only)
The aqua hose alerts users of a risk of water leaks. It senses the water
flow and turns red on the centre indicator (A) in case of a leak.
STEP 5 - Position the drain hose
The drain hose can be positioned in three ways:
Over the edge of a wash basin
The drain hose must be placed at a height of between 60 cm and 90
cm (*) from the floor. To keep the spout of the drain hose bent, use the
supplied plastic hose guide (A). Secure the guide to the wall using a
hook to ensure stable drainage.
ln a sink drain pipe
The drain pipe must be above the sink siphon so that the end of the hose is at least 60 cm above the floor.
ln a drain pipe
The drain pipe should be between 60 cm and 90 cm high (*). It is
advisable to use a 65 cm high vertical pipe. Make sure the drain hose is
connected to the stand pipe at a slant.
Drain standpipe requirements:
• Minimum diameter of 5 cm
• Minimum carry-away capacity of 60 litres per minute
STEP 6 - Turn on the washing machine
TPlug the power cord into a wall socket featuring an AC 220-240V / 50Hz approved electrical outlet
protected by a fuse or circuit breaker. Then, press the Power button to turn on the washing machine.
To Next Page
Loading...
