Samsung WW90T534DAW - Troubleshooting; Information Code

30 _ Troubleshooting
4. TROUBLESHOOTING
4-1. INFORMATION CODE
► When an abnormal condition occurs, melody sounds and displays Info. code indications as shown in the following Info. codes
are shown until the status has cleared.
No. Information Type
Information
Code
Causes Corrective Actions
1 WaterLevel 1C
- Thepartofthehosewherethewaterlevelsensoris
locatedisdamaged(punctured).
- Thehoseiscloggedwithforeignmaterial.
- Thehoseisfolded.
- Toomuchlubricanthasbeenappliedtotheinsertion
partoftheairhose.
- Hoseengagementerror(disengaged)
- Partfault(Faultyinternalsoldering)
- Thewaterlevelsensorterminalisdisengaged.
- MainPBAfault
•Waterlevelsensorfault.
•Thewaterlevelsensorterminalis
disengaged.
•Thepartofthehosewherethe
waterlevelsensorfolded.
•MainPCBfault.
2 Motor
3C
- ThePBAconnectorterminalisnotconnected.
- Themotorspinnetisnotengaged.
- Themotor’sinternalcoilisdamaged(short-circuited
orcut)
- Foreignmaterial(ascrew)hasenteredthemotor.
•Washingmotorfault.
•CheckWashingmotorconnector.
•Washingmotorrotor/statorfault.
•MainPCBfault.
3C1
- Motoroverloadedduetotoomuchlaundry(Non
sensing)
- PBAfault
3C2
- ThemotordrivingerrorfromthePBAisweak:
Unstablerelayoperation,etc.
3C3
- TheIPMterminalofthemainPBAisnotconnected.
- TheDDmotorcoverisoutofplace.
3C4
- ThePCBhousingterminalisnotconnected.
- PBAfault
- DDmotorfault
3 WaterSupply
4C
- Foreignmaterialisenteringthewatersupplyvalve.
- Thewatersupplyvalveterminalisnotconnected.
(Wiredisconnected)
- Thewarmwaterandrinseconnectorsarewrongly
connectedtoeachother.
- ThisoccursifthePCBterminalfromthedrainhoseto
thedetergentdrawerisnotconnected.Checkwhether
thetransparenthoseisfoldedortorn.
- ThisoccursWaterpressureisweak,acertaintime
delay.
- ThisoccursWaterValvebyfreezinginwinterseason.
•Watersupplyvalvefault.
•MainPCBfault.
•Freezingbywinterseason.
4C2
- Thewatertemperatureissensedashigherthan50˚C
intheWoolorLingeriecourses
-
4 Drain 5C
- Thepumpmotorimpellerisdamagedinternally.
- Thewrongvoltage(220V→110V)issuppliedtothe
parts.
- Partfault
- Thisoccursduetofreezinginthewinterseason.
- Thedrainhoseisclogged.(Injectionerror,foreign
material)
- Cloggedwithforeignmaterial.
- Thewaterpumpterminalisnotconnected:rubber
band,bills,cotton,hairpins,coins.
•Drainpumpfault.
•Freezingbywinterseason.
•Checkinsideforeignmaterialof
drainpump.
•MainPCBfault.