ManualsAndTutorials www.manualsandtutorials.com
From Offical Samsung Page. All right reserved.
SAMSUNG XPRESS SL-M2022 | User Guide
Shared Key: Authentication is used. A device that has a proper WEP key can access the network.
Encryption: Select the encryption (None, WEP64, WEP128).
Network Password: Enter the encryption network password value.
Confirm Network Password: Confirm the encryption network password value.
WEP Key Index: If you are using WEP Encryption, select the appropriate WEP Key Index.
The wireless network security window appears when the ad hoc network has security enabled.
Select Open System or Shared Key for the authentication and click Next.
WEP (Wired Equivalent Privacy) is a security protocol preventing unauthorized access to your wireless network. WEP encrypts the data portion of each
packet exchanged on a wireless network using a 64-bit or 128-bit WEP encryption key.
8. The window showing the wireless network setting appears. Check the settings and click Next.
Before entering the IP address for the machine, you must know the computer’s network configuration information. If the computer’s network configuration is set
to DHCP, the wireless network setting should also be DHCP. Likewise, if the computer’s network configuration is set to Static, the wireless network setting
should also be Static.
If your computer is set to DHCP and you want to use the Static wireless network setting, you must contact the network administrator to get the static IP address.
For the DHCP method
If the IP address assignment method is DHCP, check if DHCP is shown in the Wireless Network Setting Confirm window. If it shows Static, click Change
TCP/IP to change the assignment method to Receive IP address automatically (DHCP).
For the Static method
If the IP address assignment method is Static, check if Static is shown in the Wireless Network Setting Confirm window. If it shows DHCP, click Change
TCP/IP to enter the IP address and other network configuration values for the machine.
For example,
If the computer’s network information is as shown follows:
IP address: 169.254.133.42
Subnet Mask: 255.255.0.0
Then, the machine’s network information should be as below:
IP address: 169.254.133.43
Subnet Mask: 255.255.0.0 (Use the computer’s subnet mask.)
Gateway: 169.254.133.1
9. The Wireless Network Setting Complete window appears. Click Next.
10. When the wireless network settings are completed, disconnect the USB cable between the computer and machine. Click Next.
11. Follow the instructions in the installation window.
To Next Page
Loading...
