1. INTRODUCTION .................................................................................. 3
2. SAFETY RULES .............................................................................. 3 - 4
3. EQUIPWENT ................................................................................... 4 - 6
3.1 WARRANTY ............................................................................................. 4
3.2 IMPORTANT ............................................................................................ 5
3.3 IDENTIFICATION ............................................................................... 5 - 6
4. START - UP ..................................................................................... 6 - 9
4.1 MACHINE PLACEMENT ......................................................................... 6
4.2 SELECTING DIES .................................................................................. 6
4.3 P20D CONTROL PANEL lLLUSTRATION .............................................. 7
4.4 CHANGE OF A SINGLE DIE ................................................................... 8
4.5 CRIMPING ............................................................................................... 8
5. SELECTING THE DIE SET, 20 MODEL ............................................... 9
6. IF THE MACHINE DOES NOT WORK ............................................... 10
7. RE-CALIBRATION OF CRIMPING DIAMETER DIAL ......................... 11
8. TROUBLE SHOOTING ................................................................................ 11
9. SAMWAY P20D .................................................................................. 12
CONTENTS
P20D USER MANUAL EDITION 2019 www.samway.com
samwaysales@gmail.com sales@samway.comPage 2
All Die Sets Required to be installed Clockwise 1 2 3 4 5 6 7 8 if you look
infront of the crimping machine. Die number 1 could install to any master
die, but the folowing die number 2 should be beside the die number 1 and
clockwise. Especially for the die number under under 16 mm . This is
important to keep the ferrule crimped with good roundness.
Caution
To Next Page
Loading...
