P20D
4. START-UP
4.1 Machine placement
Place the machine on a stable and flat surface.
4.2 Selecting dies
Determine the crimping dimensions for the current operation and select the die set with the correct interval
that corresponds to the crimping measurement.
For example: A crimping measurement of 17mm requires the die size nr 16 (since it covers the 16-19 mm
interval).
Always select the die set within the correct interval to achieve the best crimping results. Every die is marked
with the smallest crimping measurement in the interval.
Note!
Crimping any measurements outside the table crimping measurement interval is not recommended.
USing dies that are too small risk the ferrule becoming oval.
P20D USER MANUAL EDITION 2019 www.samway.com
samwaysales@gmail.com sales@samway.comPage 6
To Next Page
Loading...
