S&C Vista - Motor Operator Decoupling Steps

22 S&C Instruction Sheet 682-510
Operation
Motor Operator Decoupling
STEP 1� Loosen and remove the bolt from the stop
ring located on the operating disk collar. See
Figure35.
STEP 2� Lift the motor operator over the operating shaft
of the gear. See Figure 36.
STEP 3� For submersible applications, do not remove the
cable from the motor operator. See Figure37.
Figure 35� Loosen the bolt�
Figure 36� Lift the motor operator�
Figure 37� Do not remove cable�
Cable connection