Voice Recording
To record your voice as file to your player. Follow these steps:
1. Press the Power/Menu Button once. The SanDisk logo and Sansa logo will briefly
appear onscreen then disappear. (Can’t find the Power/Menu Button on your
player? See The Basic Controls section on page 3.)
WARNING: If the onscreen message says "Locked" and then shuts off, locate
the Hold Button on the left side of your player. Slide that button left to unlock
your device. Then repeat Step 1 above. See The Basic Controls section on
page 3 if you cannot find the Hold Button.
NOTE: If you do not see the recorder onscreen, briefly press the Power/Menu
Button on the right side of your player. The software Menu will appear. Press the
Repeat/AB/Down Button or the Play/Pause/Up Button to scroll through the Menu.
Highlight Recorder mode and press the Select Button to enter Recorder mode.
2. Press the Power/Menu Button briefly to access the software Menu then press the
Repeat/AB/Down or the Play/Pause/Up Button to highlight Recorder mode. Press
the Select Button to enter Recorder mode.
3. Press the Play/Pause/Up Button to start recording.
4. During recording, if the Play/Pause/Up Button is pressed, the recording will pause,
and if the Play/Pause/Up Button is pressed again, recording will resume.
5. To stop recording, you have two choices:
■ Press the Repeat/AB/Down Button.
■ Press the Power/Menu Button.
6. To save the recorded file, you have two choices:
■ During the recording, if one press Repeat/AB/Down Button or Power/Menu
Button, the recording will be stopped and displayed the message of
confirming to save a file or not. Press Next/Fast Forward Button or
Previous/Fast Reverse Button, to toggle between (delete) and (save).
Press Select Button to delete or save a file.
■ Press and hold down the Power/Menu Button until all the dark squares
disappear under the "Powering Down" message.
Quick Start 7
▲
To Next Page
Loading...
Need help?
General
