16
GB
FM stereo / mono
If the FM radio station being listened to has a weak signal some hiss may be audible. It is
possible to reduce this hiss by forcing the radio to play the station in mono rather than stereo.
1. Press the Band button as needed to select the FM radio mode and tune to the required FM
station as previously described.
2. Press and hold the Menu / Info button to enter the menu setting.
3. Press and release the Tuning up / down button until ‘FM Audio’ shown on the display. Then
press the Select button to enter the setting. If the setting is Auto press the Tuning up / down
button to switch to Mono mode to reduce the hiss.
4. To return to Auto (stereo) mode press and release the Tuning up / down button again, so that
the digital receiver will switch back to Auto mode.
To Next Page
Loading...
