Sangean DT-120 - Manual Tuning; Memory Tuning and Presets

Turn on the radio by pressing and
holding POWER/BAND button. Select
required band by pressing POWER/
BAND button. Tune to the desired
station using the Scan or Manual tuning
steps described above. When the
desired station is reached, press and
hold Memory button (1-5) for more than
2 seconds until display M x stop ashing
followed with a beep (via earphone). It
will replace previous memory station.
You may store 5 memory stations in
each band (AM, FMI, FMII).
Manual Tuning
Turn on the radio, select desired band
by pressing POWER/BAND button.
Desired station may be selected
by turning the Tuning jog wheel
intermittently until the desired station
is reached. Or turning and holding
the Tuning jog wheel until the desired
station is reached.
Memory Tuning (Station
preset)
7