Sangean PR-D3L - Advanced Alarm and Reception; HWS Alarm Operation; Snooze Function Operation; Waveband Selection and Reception

HWS ALARM
SNOOZE
RADIO OPERTION
WAVEBAND SELECTION
8
A repeating beep tone will sound when using HWS alarm.The
alarm beep will increase in volume every 15 seconds for one
minute followed by 1 minute silence before repeating the cycle.
The HWS alarm will sound for one hour unless turned off by
pressing the POWER button.
When the alarm is on,press any buttons except POWER button,
the alarm will be in Snooze function for an interval of 5 minutes
before pressing POWER button to turn it off.Display will flash
Snooze symbol and alarm status.
There are three wavebands in PR-D3L unit
Waveband Frequency Aerial Type
FM 87.5-108 MHz Telescopic
Fully extend the aerial,
angle and rotate for best
Reception.
MW 522-1710KHz Internal
Rotate for best reception.
LW 144-279KHz same as MW
There are 4 different available tuning methods:
Manual tuning,Rotary tuning,Scan tuning and Memory recall
tuning.
All manuals and user guides at all-guides.com