8
TO POOL
PUMP
FILTER
TOOLS NEEDED
Screwdriver
Pipe Wrench
MATERIALS NEEDED
Pipe Thread Tape
or Sealant
Two hose adapters
1½” X 1½” X 1¼”
Two Sections of 1½”
or 1¼” Flex Hose (one
provided with lter)
Two
Hose
Clamps
RECOMMENDED
4-8 psi Back Pressure
To avoid over or under
chlorination, replace eyeball
ttings in the return jets to a
smaller or larger size to adjust
back pressure. For best results
use King Technology’s pressure
gauge, order part number
01-22-4000.
Apply pipe thread tape or sealant
to the threaded end of both hose
adapters.
1.
Base Flex-Hose Installation - Model 920
Screw adapters into each end of Perform-
Max Feeder. Hand tighten. Finish tightening
by turning 1 to 2 revolutions with pipe
wrench. DO NOT OVER TIGHTEN.
2.
Attach the lter section of ex hose to one hose adapter
and the return section of ex hose to the other hose
adapter with clamps and tighten with screwdriver. Bi-
ow valve design allows water ow installation in either
direction.
3.
To prevent damage to heaters
or lters, install a corrosion
resistant check valve which will
reduce the back ow of chlorine
gas when the system is turned
off.
4.
For better stability, Perform-Max Feeder may be
mounted on a treated wood base using Phillips
pan head screws, one in front and two in back. If
you have questions about stability, please contact
your dealer or King Technology.
5.
CHECK
VALVE
BUSHING
HOSE
CLAMP
HOSE
ADAPTER
HOSE
CLAMP
HOSE
ADAPTER
TO POOL
1 1/2" OR 1 1/4"
FLEX HOSE
1 1/2" x 1 1/2" x 1 1/4"
HOSE ADAPTER
HOSE
CLAMP
FILTER &
PUMP
The Perform-Max Feeder should always
be installed between the lter and pool (or
between heater and pool if applicable). Never
install
Perform-Max Feeder before the heater
or damage to the heater could occur.
To Next Page
Loading...