SANKI MFC-S3B-F - Page 19

17 / 32
0.0
0A0.0
0u 0
0u 0
0u 1
0u 1
0.0
Press the
Func key long
for 2 sec.
Vol▼ key
※ Usage during constant
voltage mode, change 0u to 0,
confirm that 0u=0, and go to
the next operation.
Set key
Freq▲▼ keys
Change 0u to 1.
Set key
The normal mode screen
appears.
Output% screen
Blinking
Blinking
※Next, go to <③ Adjustment of amplitude>.
③ Parameter setting
Press the
Func key long
for 2 sec.
The parameter mode
screen appears.
※When the Set key is pressed after value setting, the
set value is saved.
※If the Vol
▲▼ keys are pressed without pressing the
Set key in the change process, the changes will not
be saved but cancelled.
If there is no key operation for over 5 min, the normal
mode screen (voltage display) will be forced to
reappear.
※This section describes the change of the parameters
No. 0u. Any other parameter can be changed in the
same way.
When the Vibration
Sensor KS
-3 is not used,
[Constant voltage mode]
When the Vibration Sensor
KS
-3 is used,
[Constant amplitude mode]