SANKI MFC-S3B-F - ８．Operation and Amplitude Adjustment Method

16 / 32
8. Operation and Amplitude Adjustment Method
U100
io01
0.
0.
A
n
0.0
Func key
Freq▲▼ keys
Set key
※Next, go to <③ Parameter setting>.
Program version
“io” mode
Initial screen:
Output%
① Power ON
② Switching from the
operation mode to the
adjustment mode
The following are displayed in this order:
(Each 2 seconds)
AUTO lamp goes out, and the mode
is switched to the adjustment mode.
<Adjustment mode>
⇒
In this mode, the frequency and the output%
can be adjusted, and all parameters can be set
and changed.
①Data display area
②Frequency pilot lamp
③Voltage% pilot lamp
④Operation pilot lamp
⑤Parameter pilot lamp
⑥Operation mode pilot lamp
⑦Constant amplitude control
pilot lamp
⑧Frequency lock pilot lamp
⑨Operation pattern setting
：
ON
：Blinking
：OFF
<Lamp status>
(A) ON/OFF key
(B) Func key
(C) Set key
(D) Vol▲ key
(E) Vol▼ key
(F) Freq▲ key
(G) Freq▼ key
Operation panel