5 / 32
Terminal block No.
Wiring to the external signal terminal block (screw-less)
While holding down the button on the terminal block with a flat-blade screwdriver or similar,
insert the wire into the wire insertion hole. Then, detach the flat-blade screwdriver to release
the button, and the wire will be fixed.
Applicable wire size
・Terminal block (A), (S)
Stranded wire: AWG26 - 20
Solid wire: AWG26 - 20
Wire strip length: 10 – 11mm
・Terminal block (B)
Stranded wire: AWG22 - 14
Solid wire: AWG22 - 14
Wire strip length: 9 – 10mm
To Next Page
Loading...