Sansui AU-719 - Page 28

28
Input Selector
Tape Play
source :
tape-1
Listening to radio broadcasts
1. Be sure to turn the VOLUME control fully counterclockwise before
operating any of the switches on the unit.
2. Set the INPUT SELECTOR switch to TUNER.
3. Control the tuner and tune in the desired station.
4. Adjust volume, balance and tone to your liking with controls and
switches on your unit.
Noise during radio reception
* Weak FM signals are often disturbed by ignition noise from nearby
automobiles and other noise. Therefore, for better FM reception,
installation of an outdoor FM antenna is suggested. For antenna
connection, be sure to use a coaxial! cable, not a twin lead type.
When you hear noise during AM reception, there are innumerable
conceivable causes, which makes it almost impossible to eliminate
all AM noises. Use the unit's TREBLE control when grounding the
unit .or mounting a noise-eliminating device fails to reduce such
noise.