Need help?Do you have a question about the Sansui G-2000 and is the answer not in the manual?
Steps for FM IF coil, dial calibration, and signal meter adjustment.
Procedures for adjusting FM stereo VCO and separation.
Complete schematic diagram for the Sansui G-2000 receiver.
Complete schematic diagram for the Sansui G-3000 receiver.
General| Power Output | 20 watts per channel into 8Ω (stereo) |
|---|---|
| Input Sensitivity | 2.5mV (MM), 150mV (line) |
| Frequency Response | 20Hz to 20kHz |
| Signal to Noise Ratio | 90dB (line) |
| Tuning Range | FM 88 to 108 MHz, MW 530 to 1600 kHz |
| Speaker load impedance | 4Ω to 16Ω |
To Next Page
