Need help?Do you have a question about the Sansui G-5500 and is the answer not in the manual?
General| Power output | 55 watts per channel into 8Ω (stereo) |
|---|---|
| Frequency response | 10Hz to 50kHz |
| Damping factor | 50 |
| Input sensitivity | 2.5mV (MM), 150mV (DIN), 150mV (line) |
| Dimensions | 480 x 140 x 369mm |
| Weight | 13.3kg |
| Speaker load impedance | 4 - 16 ohms |
| Channel separation | 50dB |
| Tuning range | FM: 87.5 - 108 MHz, AM: 530 - 1700 kHz |
Details on power output, distortion, frequency response, and input/output parameters.
Explains the IC-based protector circuit for DC voltage, overload, and temperature detection.
Procedures for adjusting DC offset and bias current on the driver boards.
Steps for tuning IF/RF circuits and calibrating the FM dial for accurate reception.
Adjustments for PLL VCO, separation, and muting level for stereo FM reception.
Steps for tuning AM IF/RF circuits and calibrating the dial for accurate reception.
Detailed schematic for the audio and power supply circuits.
Diagram illustrating the tuner section's circuitry and signal flow.
To Next Page
