Sansui RA-1000 - Page 4

Connections
_-—
*
Mains
plug
may
vary
to
some
extent
depending
on
sales
area,
local
laws
and
regulations.
Stereo amplifier
LINE IN-LINE OUT
(REC) (PLAY)
Tape deck-1
Connection
Precautions
*
When
connecting,
either
disconnect
the
power
plug
from
the
pow-
er
outlet
or
turn
off
the
unit’s
power
using
the
POWER
switch.
*
Before
connecting,
read
through
the
Operating
Instructions
of
the
other
audio
components
which
will
be
connected
to
this
unit.
*
Check
the
left
and
right
channels
and
connect
properly
(L
to
L
and
R
to
R).
*
Insert
the
plugs
securely.
Improper
connection
can
lead
to
the
_
generation
of
noise.
Amplifier
or
Receiver
Connections
Connect
the
TAPE
REC
terminals
on
the
amplifier
or
receiver
to
the
INPUT
terminals
on
the
RA-1000
and
connect
the
TAPE
PLAY
termi-
nals
on
the
amplifier
or
receiver
to
the
OUTPUT
terminals
on
the
RA-1000.
Tape
Deck
Connections
Connect
the
TAPE
REC
terminals
on
the
RA-1000
to
the
LINE
IN/REC
terminals
on
the
tape
deck
and
the
TAPE
PLAY
terminals
on
the
RA-1000
to
the
LINE
OUT/PLAY
terminals
on
the
tape
deck.
There
are
two
sets
of
tape
terminals
on
this
unit.
Connect.
the
se-
cond
tape
deck
to
the
TAPE-2
terminals.
~ AMD
LINE IN LINE OUT
{REC) {PLAY}
F® © Fec5
b> TAPE-1
F® © puay-
For the United Kingdom only
WD
AC
OUTLET
Power is supplied to the AC OUTLET on the rear panel when the power
cord is connected to a household AC outlet.
* The maximum capacity of this outlet is 150 watts. Connecting
an electrical appliance with a power consumption exceeding this
rating is extremely dangerous. Check the rating before connection.
Tape deck-2
ae utah Sh sn wah cage se ar hi er
NOTE: Depending on the laws and regulation enforced locally, models
without AC outlets may be supplied to some areas. Also, depending
on the sales area, the shape of the AC outlets and their capacity may
differ.
AER MP7 SELES END ST ALES ES TS MA NE TT