To Next PageTo Next Page
Need help?Do you have a question about the Santec TSL Series and is the answer not in the manual?
General| Power Stability | ±0.01 dB |
|---|---|
| Coherence Control | Yes |
| Output Power Stability | ±0.01 dB |
| Optical Output Connector | FC/APC |
| Interface | GPIB, Ethernet |
Detailed explanation of the front panel controls and indicators.
Description of connectors and interfaces on the rear panel.
Description of the bottom panel features like vents and feet.
How the diffraction grating enables wide-range wavelength tuning.
Functionality to manage spectrum linewidth and coherence.
How injection current and temp are controlled for stable operation.
Explanation of APC and ACC modes for output power control.
High-resolution wavelength tuning using electro-mechanical motor and PZT.
Procedure for powering on the unit and initial status indications.
Steps for powering on and configuring the RS-232C delimiter.
Instructions for connecting the optical fiber cable.
Procedure for cleaning the optical connector to prevent signal loss.
How to change LD current and the unit of optical output power.
Explanation of the rotary encoder's function for setting parameters.
Steps to set the desired wavelength using the rotary encoder.
How to select the minimum tuning step for wavelength adjustments.
How to set optical output power in APC mode.
Explanation of Automatic Current Control mode and its use.
How to switch the unit display between mW and dBm.
Functionality for precise wavelength adjustment with high resolution.
Using the option key for internal fine tuning control.
Using external voltage via AIF for fine tuning control.
Controls spectrum linewidth to manage interference in optical systems.
How to use external input voltage for LD modulation.
Calibrating the unit's wavelength monitor against a measuring device.
Configuring the GP-IB interface address and communication delimiter.
Procedures for safely powering down the unit and its components.
Overview and usage of the General Purpose Interface Bus.
Overview and usage of the RS-232C serial communication protocol.
Pin assignments and usage of the SIF connector for RS-232C.
Commands for changing internal conditions and external parameters.
Methods for retrieving output data via GP-IB and RS-232C.
Interpreting status codes displayed by the unit.
Example programs for RS-232C and GP-IB communication.
Routine cleaning and care for optimal performance.
Procedure for cleaning the optical output connector.
Steps for replacing the power source fuse.
Information on recommended inspection and calibration intervals.
How to use the high frequency modulation input terminal.
Features and connection of the optional control pad for enhanced operation.
Functionality and control methods of the built-in attenuator option.
