Need help?Do you have a question about the Santec MPM-210H and is the answer not in the manual?
General| Brand | Santec |
|---|---|
| Model | MPM-210H |
| Category | Measuring Instruments |
| Language | English |
Explains the structure and content of the MPM-210H operation manual for effective use.
Details warning symbols and defines key terms like DANGER, WARNING, CAUTION, and NOTE.
Details the front panel layout, including power switch, LEDs, and module slots.
Describes the MPM-211 module, its 4 optical power measuring ports, and FC connector.
Details the MPM-212 module with 2 optical power ports and 2 analog output ports.
Explains the MPM-213 module for electrical current measurement and its BNC connectors.
Details the MPM-215 module for high dynamic range optical power measurement with 4 ports.
Describes the rear panel interfaces: Trigger I/O, USB, LAN, RS232C, GPIB, and power connector.
Covers essential safety warnings, cautions, and environmental guidelines for safe operation.
Details line voltage, fuse replacement, power cord connection, zeroing option, and max input power.
Provides instructions on how to correctly insert measurement modules into the MPM-210H mainframe.
Details the setup and connection requirements for GPIB communication with the MPM-210H.
Explains the computer settings required for TCP/IP network communication with the MPM-210H.
Covers the setup and configuration for RS-232 serial communication, including baud rate and data bits.
Defines the general format and syntax rules for sending commands to the MPM-210H.
Lists available system-related and measurement-related commands with their descriptions and page numbers.
Details commands for system configuration, identification, and status checking.
Details commands for setting measurement modes, wavelengths, gain, and triggers.
Explains how to retrieve error information using the ERR? command and lists common error codes.
Describes the procedure for wavelength calibration and compensation using CWAV? and CWAVPO? commands.
Details commands for setting and checking the power measurement range (Auto/Manual).
Explains the different measurement modes like CONST1, SWEEP1, CONST2, SWEEP2, and FREERUN.
Details the timing and gain switching behavior during SWEEP2 measurement mode.
Covers setting measurement data points with LOGN and retrieving logging data with LOGG?.
Details the configuration parameters for FREERUN measurement mode and provides a sample command sequence.
Provides a practical example of commands for setting up and executing SME mode measurements.
Explains the electrical characteristics and timing of the external trigger input signal.
Describes the electrical characteristics of the trigger output signal for high and low states.
Lists detailed technical specifications for MPM-211, MPM-212, and MPM-215 modules.
Provides detailed technical specifications for the MPM-213 current meter module.
Details the specifications of the MPM-210H mainframe, including interfaces and power.
Lists the EMC, Safety, and RoHS standards that the MPM-210H conforms to.
Provides guidance on routine cleaning and maintenance for the instrument and its optical sensor.
Details procedures for replacing fuses and preparing the instrument for long-term storage.
Explains the correct procedure for re-packing the instrument to prevent damage during shipment.
Provides instructions on handling and orienting the shipping box to ensure safe transit.
Lists common fault conditions, their causes, and recommended actions for resolution.
To Next Page
