Santec MPM-210H - Error Handling with ERR?

MPM-210H OPERATION MANUAL
42 / 59
Example
LOGN 100
34. LOGN?
Description
Check measurement data point.
Refer to the 5.6.3 Measurement data setting (LOGN).
Syntax
LOGN?
Response
<value>: 1 ~ 1,000,000
Example
LOGN?
Response: 100
35. LOGG?
Description
Read out the logging data.
This command is not available for RS-232 communication.
Syntax
LOGG? <wsp><value1>,<value2>
<value1>: module number
<value2>: port number
Response
Please refer to ‘5.6.4 LOGG?’ for detail information.
Example
LOGG?
Response: Please refer to ‘5.6.4 LOGG?’ for detail
information.
36. ZERO
Description
Before measuring optical power, run Zeroing to delete
electrical DC offset. Please be careful with incidence light
into Optic Port. When using the current meter module,
the MPM-213, please remove the BNC cable from the
MPM-213. This command action takes about 3 sec so
please run other commands at least 3 sec later.
Syntax
ZERO
Example
ZERO
5.5.5 ERR?
All kinds of errors will be saved into message Que. By using a command ‘ERR?’,
users can pull out error information and read them all.