Santec MPM-210H - System-Related Commands

MULTI-PORT OPTICAL POWER METER MPM-210H
27 / 59
FGSAVG/FGSAVG?
Sets up/Reads out Average Time. (This command
is same operation as “AVG”.)
37
UNIT/UNIT?
Sets up/Reads out measuring unit of optical power
or electrical current.
38
AUTO/AUTO?
Sets up/Reads out the power range (Auto or
Manual).
38
DAUTO/DAUTO?
Sets up/Reads out the power range (Auto or
Manual) for each channels.
39
READ?
Execute optical power or electrical current
measurement and check the result.
39
CWAV?
Checks the wavelength that should be calibrated.
40
CWAVPO?
Checks Power calibration value of the wavelength
of “CWAV?” command Index.
40
MEAS
Command to start measuring.
41
STOP
Command to stop measuring.
41
STAT?
Checks the measuring status.
41
LOGN/LOGN?
Sets up/Reads out measurement data point in
CONST1/CONST2/FREERUN measuring mode.
41
LOGG?
Read out the logging data.
42
ZERO
Before measuring optical power, run Zeroing to
delete electrical DC offset.
42
5.5.2. Command compatible with the previous MPM-210 model
The MPM-210H is command compatible with the previous MPM-210 model, so
switching to the new MPM-210H is as simple as swapping out your devices.
5.5.3. System-related commands
1. ECHO
Description
Definite echo (For only RS-232 Communication)
Syntax
ECHO<wsp><value>
Parameters
0 : Disable
1 : Enable
Default
0
Example
ECHO 0
2. *IDN?
Description
Identification Query
Syntax
*IDN?