Santec MPM-210H - System and Measurement Command Lists

MPM-210H OPERATION MANUAL
26 / 59
Not acceptable for dividing COMMAND & Parameter
' ` ', ' \t '
・ Special characters process as follows (When receiving)
BS(back space)
Delete last received character
<CR>(Carriage Return)
Ignore
<LF>(Line Feed)
Handles it as a Terminating character.
5.5. Commands
5.5.1. Commands list
1) System-related commands
Command
Description
Page
ECHO
Definite echo for RS-232 communication
27
*IDN?
Identification Query
27
ERR?
Check Error information.
28
IDIS?
Check recognition of MM for MPM-210H.
28
MMVER?
Identification query of a module type
28
ADDR/ADDR?
Sets/Reads out the GPIB address.
29
GW/GW?
Sets/Reads out the Gate way Address.
29
SUBNET/SUBNET?
Sets/Reads out the SUBNET Address.
30
IP/IP?
Sets/Reads out the IP Address.
30
2) Measurement-related commands
Command
Description
Page
TRIG/TRIG?
Sets up/Reads out the trigger mode.
30
WMOD/WMOD?
Sets up/Reads out the measurement mode.
31
WAV/WAV?
Sets up/Reads out the measurement wavelength
of Constant wavelength Measurement Mode
(CONST1, CONST2, READ).
32
DWAV/DWAV?
Sets up/Reads out the measurement wavelength
of Constant wavelength Measurement Mode
(CONST1, CONST2, READ) for each channels.
33
WSET/WSET?
Sets up /Reads out the measurement wavelength
of Sweep Wavelength Measurement Mode
(SWEEP1, SWEEP2).
33
SPE/SEP?
Sets up/Reads out the Wavelength Sweep Speed
34
LEV/LEV?
Sets up/Reads out TIA Gain for CONST1, SWEEP1,
AUTO1 measuring mode.
35
DLEV/DLEV?
Sets up/Reads out TIA Gain for CONST1, SWEEP1,
AUTO1 measuring mode for each channels.
35
AVG/AVG?
Sets up/Reads out Average Time.
36