MULTI-PORT OPTICAL POWER METER MPM-210H
17 / 59
4. Installation
4.1. Warning and Caution
・ Dangerous voltages, capable of causing injury or death, are present in this
instrument. Use extreme caution whenever the instrument covers are
removed. Do not remove the covers while the unit is plugged into a live
outlet.
・ To avoid electric shock, the power cord protective ground conductor must be
connected to ground.
・ No user serviceable part exists in this instrument. Refer all services to
qualified personnel.
・ Before using this instrument, be sure to read through operation manual and
data sheets to ensure correct operations. Contact SANTEC to obtain service
support and do not install substitute parts or perform any unauthorized
modifications to this instrument.
4.2. Environment
Pay attention to the following guidelines for safe, trouble-free operation.
This product is a high-precision device and be designed to be used indoors
(Pollution Degree 2):
・ Do not place in direct sunlight.
・ Do not place under high temperature and high humidity.
・ Do not place in an environment with dust, dirt, salt, or corrosive gas.
・ Do not place in an area subject to large vibrations.
・ Do not place in an area subject to noise by electric field, magnetic field, etc.
・ Do not place in an area where the unit is subject to falling objects landing on
it.
・ Do not place with possible exposure to water.
・ Do not place with an area of altitude 2000m or more.
Clearance of 5 cm at the rear side of the unit should be allowed for proper
ventilation. Don't remove rubber feet to ensure air intake.
The mainframe of the MPM-210H weighs about 6.0 kg. Please ensure that the
table or shelf upon which it is installed has sufficient strength.
To Next Page
Loading...
