Santec MPM-210H - Page 41

MULTI-PORT OPTICAL POWER METER MPM-210H
41 / 59
Index : Wavelength set order that would be applied –
Integer 1,2,3~ 18,19
Response
<optical power offset> - float
Example
CWAVPO? 0,1,1
Response: 0.904640
30. MEAS
Description
Command to start measuring.
Syntax
MEAS
Example
MEAS
31. STOP
Description
Command to stop measuring.
Syntax
STOP
Example
STOP
32. STAT?
Description
Check measuring status.
Syntax
STAT?
Response
<value1>,<value2>
<value1>: Status
0 – Measuring is still in process.
1 – Measurement completed.
-1 – The measurement is forcibly stopped.
<value2>: Measured logging point
Example
STAT?
Response: 1,100
33. LOGN
Description
Set up measurement data point in
CONST1/CONST2/FREERUN measuring mode.
Refer to the 5.6.3 Measurement data setting (LOGN).
Syntax
LOGN<wsp><value>
Parameters
<value>: 1 ~ 1,000,000
Default
value: 1