Why is the stirring motor not working on my Santint Dispenser?
The stirring motor might not be working on your Santint Dispenser due to several reasons: the machine isn't powered on, the fuse is broken, the motor isn't connected, or the motor itself is broken. To resolve this: 1. Check the power supply. 2. Change the fuse. 3. Open the side door and reconnect the wire. 4. Change the motor.
Why is colorant difficult to dispense from my Santint A4b Dispenser?
If colorant is difficult to dispense from your Santint Dispenser, it could be due to a blocked nozzle, a broken valve motor, or a valve handle that cannot open. Here's how to address these issues: 1. Clean the nozzle. 2. Change the valve motor. 3. Adjust the motor and valve position.
What to do if colorant doesn't dispense continually from Santint A4b?
If the colorant doesn't dispense continually from your Santint Dispenser, it could be due to air in the pump cylinder, a low colorant level, or dry and blocked colorant. To fix this: 1. Purge the cylinder. 2. Add more colorant. 3. Clean the canister.
Why is there abnormal noise from the step motor in my Santint A4b?
Abnormal noise from the step motor in your Santint Dispenser can be caused by several factors: the voltage being out of the normal range, the screw and guiding rod not being lubricated, or a loosened fastening screw. To resolve this: 1. Check the power supply. 2. Lubricate the screw and guiding rod. 3. Fasten the screw.
What causes the piston to be difficult to move in Santint Dispenser?
If the piston is difficult to move in your Santint Dispenser, it could be due to dried colorant inside, a lack of lubrication on the screw and guiding rod, or a loosened fastening screw. Here's how to address the problem: 1. Empty the colorant and clean the canister and pump cylinder. 2. Lubricate the screw and guiding rod. 3. Fasten the screw.
What to do if LCD shows “Emergency Button Pressed” on Santint A4b?
If the LCD shows “Emergency Button Pressed” on your Santint Dispenser, it means either the emergency button is pressed or the button is broken (or the wire is disconnected). You should release the emergency button, or change the emergency button or connect the wire.
Why has colorant appeared on the nozzle of my Santint A4b Dispenser?
If colorant has appeared on the nozzle of your Santint Dispenser, the sealing washer is likely damaged. You should change the sealing washer.
How to fix a loose canister on Santint A4b Dispenser?
If the canister on your Santint Dispenser is loose, the fastening screw is likely loose. Fasten the screw to secure the canister.
What should I do if the LCD shows “Door Open” on my Santint Dispenser?
If the LCD shows “Door Open” on your Santint Dispenser, the door is not closed properly. Ensure that you close the door well.
Instructions for mixing colorants, filling canisters, and assigning them in the software.
Procedure to remove air from pumps for accurate dispensing and filling the cup.
Guidelines for recalibrating the machine after colorant filling, requiring a scale and densities.
Procedure for positioning the base paint can for punching and dispensing operations.
To Next Page
General
