Santint
Automatic Shaker V1.0 8
Attention:
1. No idling and/or overloaded running!
2. Press down the emergency stop button immediately in case there is any abnormal noise while
shaking. The machine shall not be restarted until the issue is solved.
3. Press down the emergency stop button if there is any issue or the machine is locked while
initializing or clamping. Then re-initialize the machine.
4. Disconnect the power supply prior to cleaning.
7. Maintenance of the equipment
Daily maintenance shall be done to optimize the machine performance.
1) Only authorized personnel are allowed to dismantle the machine.
2) Lubricate the guide pillar in three months. Lubricate the two guide screws with lithium grease
in six months (Fig. 7.1).
3) Lubricate the positions shown in Fig. 7.2 with lithium grease yearly.
4) Any issue shall be solved timely!
To Next Page
Loading...