CLEANING:
IMPORTANT:
• In all circumstances, the machine should be stopped and the machine's
power supply cable (10) unplugged.
• Do not clean with a water spray or pressure jet
Clean the dose measurer regularly with a brush.
Make sure that the walls of the coffee dispensing conduit and the 6 branches of the
cross-pieces are always clean.
MAINTENANCE
Before carrying out any work on the machine, it must be unplugged from the mains and
the motor start capacitor discharged.
Discharging the capacitor:
• Unscrew the 2 screws located under the machine in the middle of the base plate
(fig. M and fig. T).
• Withdraw the electrical components unit (25) from the base plate.
• Using a screwdriver with an insulated handle, touch the 2 capacitor connections
(15). If you see an electric arc, this means that the capacitor has been discharged.
IMPORTANT: Use of spare parts other than certified original SANTOS
parts is prohibited
Discharging the capacitor:
• Unscrew the 2 screws located under the machine in the middle of the base plate
(fig. E).
• Pull the electrical components unit (20) out of the base plate.
• Using a screwdriver with an insulated handle, touch the 2 capacitor connections
(15). The sight of an electric arc shows that the capacitor has been discharged.
Spare parts:
This machine requires no specific maintenance. The bearings are lubricated for life.
If work is required to replace worn parts such as the grindstones or the electric or other
components, refer to the parts list (see exploded view at the end of the manual).
For all spare part orders (see references in the exploded view at the end of the manual),
state:
the type,
To Next Page
Loading...