13
3
4
15
3 ½ in. (8.9 cm)
7/32 in.
(5.5 mm)
CAUTION:
Avoid potential personal injury or property damage! All lag bolts
17
MUST BE firmly tightened to prevent unwanted
movement of the wall plate
16
. Ensure the wall plate is securely fastened to the wall before continuing on to the next step.
Go to STEP 3 on PAGE 16.
18
17
3. Drill pilot holes using a 7/32 in. (5.5 mm) diameter drill bit. Remove wall plate template
15
.
IMPORTANT: Pilot holes must be drilled to a depth of 3½ in. (8.9 cm). Be sure to drill into the center of the stud.
4. Install wall plate
16
using four lag bolts
17
17
16
18
and four washers . Tighten the lag bolts
17
only until the washers are pulled firmly
against the wall plate .
16
16
To Next Page
