Sanus SLT4 - Step 2 A: Wood Stud Installation (Continued); Remove Template; Securely Tighten Wall Plate

11
06
6
REMOVE TEMPLATE
Remove the wall plate template and discard.
07
4X
08
Install the four lag bolts
08
and washers
09
and firmly tighten until they
are pulled flush against the wall plate
07
.
Go to STEP 3 on PAGE 18.
7
SECURELY TIGHTEN
All four lag bolts
08
and washers
09
MUST BE firmly tightened to prevent
unwanted movement of the wall plate
07
.
Ensure the wall plate is securely
fastened to the wall before continuing on to the next step.
CAUTION: Avoid potential personal injury or property damage!
09