Sanwa PM3 - MEASUREMENT PROCEDURES; Start-up Inspection

【5】MEASUREMENT PROCEDURE
5-1 Start-up Inspection
WARNING
1. Be sure to pre-check the meter
before use.
2.Do not use a damaged meter
and test leads.
3. Check continuity of test leads.
4. When a battery exhaust mark
appears in the display, replace
the battery with a new one.
＊note:Non-marking may suggest that a battery be exhausted.
YES
YES
YES

NO
NO
Main unit
and test leads
damaged?
Is a battery
Exhaustion mark is
on?(*note)
Display shows
000.0〜1.0?
Short the RED and
BLACK test pin
Set the function
switch toΩ.
Replace the battery.
Please check again
Stop using it and have
it repaired.
To avoid danger of shock hazard,
do not use multimeter with
damage and repair the meter.
End of pre-check
START
NO
ー5ー