To Next Page

To Previous Page

Operation with the Remote Control Unit (continued)

2. Manual Operation

Check that the circuit breaker on the power panel is turned on.

If the automatic operation settings of the unit do not meet your needs, press the

setting buttons as described below and change the settings as desired.

STEP 1 Press the MODE selector button and select the desired mode.

For heating operation →

For dehumidifying operation →

For cooling operation →

For fan only operation →

STEP 2 To start the air conditioner, press the ON/OFF operation button.

STEP 3 Press the TEMP. setting buttons to change the temperature

setting to the desired temperature.

Adjustable temperature range:

STEP 4 Set the FAN SPEED selector button to the setting you want.

STEP 5 Press the FLAP button and set the airflow direction as desired.

(Refer to “Adjusting the Airflow Direction” on page 21.)

To stop the air conditioner, press the ON/OFF operation button again.

STEP 2

STEP 1

STEP 3

STEP 4

STEP 5

NOTE

30 °C max.

16 °C min.

or 86 °F max.

60 °F min.

OI-802-13EG

01_KHS0971_EN.fm Page 13 Monday, July 9, 2007 3:10 PM

Sanyo CH0971 User Manual

Questions and Answers: