Sanyo CHDZ07263 Service Manual

2 - 31
Remote Control Functions
3. Timer Remote Controller
1
2
3
4
5
6
7
8
3-15. Simple Settings Function
• This allows the filter lifetime, operating mode prior-
ity change, central control address, and other set-
tings to be made for an individual or group-control
indoor unit to which the remote controller used for
simple settings is connected.
When this function is engaged, operation stops at
the individual or group-control indoor unit to which
the remote controller for simple settings is con-
nected.
<Procedure>
Press and hold the
and
buttons
simultaneously for 4 seconds or longer.
“ ,” unit No. “ ” (or “ ” in the case of
group control), item code “ ,” and settings data
“ ” are displayed blinking on the remote
controller LCD display. At this time, the indoor unit
fan (or all indoor unit fans in the case of group
control) begins operating.
If group control is in effect, press the
button and select the address (unit No.) of the
indoor unit to set. At this time, the fan at the
indoor unit begins operating.
* If unit No. “ ” is displayed, the same setting
will be made for all indoor units.
Press the temperature setting /
buttons to select the item code to change.
Press the timer time / buttons to select
the desired setting data.
* For item codes and setting data, refer to the
following page.
Press the button.
(The display stops blinking and remains lit, and
setting is completed.)
Press the button to return to normal remote
controller display.
7
3
1 6 5
4
2
SM830183-003WAYECO-i.indb31SM830183-003WAYECO-i.indb31 2010/03/0311:14:442010/03/0311:14:44

Sanyo CHDZ07263 Specifications

General

Refrigerant	R410A
Cooling Capacity	7.2 kW
Power Supply	220-240V, 50Hz
Operating Temperature (Cooling)	18°C to 43°C
Operating Temperature (Heating)	-7°C to 24°C