Sanyo DC-DA280 - PRECAUTIONS; Environmental and Placement Warnings; Operational and Safety Guidelines; CONNECTIONS

CLASS 1 LASER PRODUCT
LUOKAN 1 LASERLAITE
KLASS 1 LASERAPPARAT
CAUTION
THIS PRODUCT CONTAINS
A LOW POWER LASER
DEVICE, TO ENSURE CON-
TINUED SAFETY DO NOT RE-
MOVE ANY COVERS OR AT-
TEMPT TO GAIN ACCESS TO
THE INSIDE OF THE
PRODUCT.
REFER ALL SERVICING TO
QUALIFIED PERSONNEL.
IMPORTANT
If the plug supplied with this equipment is not suitable for the socket
outlets in your home it should be cut off and replaced with the correct
type.
Disposal of Plug
If the non rewireable plug is to be cut off, the removed plug should be
disposed of carefully as there is a shock hazard should the plug be
inserted into a live socket.
Replacing Fuse
The detachable fuse cover must be replaced after changing the fuse.
Only a 3A fuse should be used and should comply with BS1362 and
should carry the ASTA mark æ
E niideti id Bhein TEAM PARE LER UR BEE
- The apparatus shall not be exposed to dripping or splashing.
- No objects filled with liquids, such as vases, shall be placed on the
apparatus.
- Donotuse where there are extremes of temperature (below 5°C or
exceeding 35°C) or where direct sunlight may strike it.
- Because of the CD player's extremely low noise and wide dynamic
range, there might be a tendency to set the volume on the amplifier
unnecessarily high. Doing so may produce an excessively large
output from the amplifier which could damage your speakers.
- Sudden changes in the ambient temperature may cause condensa-
tion to form on the optical lens inside the unit. If this happens, take
out the disc, leave the unit for about 1 hour, and then proceed to
operate.
- The system’s speakers use powerful magnets. Do not place time-
pieces, credit cards, cassette tapes or video tapes, etc. near the
speakers.
Do not install this equipment in a confined space, such as a book
case or built in cabinet.
The wires in the mains lead are coloured in accordance with the
following code;
Blue Neutral
Brown Live
The wires in the mains lead must be connected to the terminals in the
plug as follows;
Wire colour Plug terminal marking
Blue N or Black or Blue
Brown L or Red or Brown
Do not connect either wire to the earth terminal.
If the mains plug contains a fuse this should be 3A, if a plug without a
fuse is used the distribution board fuse should not be greater than 5A.
The unit is not disconnected from the mains unless it is unplugged from the AC outlet
R ch speaker L ch speaker
, <a | ji
-o RISK OF ELECTRIC SHOCK
ae DONET OPEN oof
4.5 RISGLE TE HOC ELESTRICLE.NE PAS SUYRIR
de R
SPEAKERS
(4a. MIN )
To an AC outlet
AM loop aerial Note:
- Do not connect the mains lead to an
AC outlet until all connections have
been made.
- The system is not completely discon-
nected from the mains when the power
FM
aerial
button
is
set
to
the
m
OFF
position.
Speakers
Connect the connector of the left speaker
lead to the “L” SPEAKERS socket and the
connector of the right speaker lead to the
“R” socket.
if you have difficulty inserting the speaker
lead connector, turn it over and reinsert it.
FM aerial
FM indoor aerial is sufficient to receive
broadcasts. Extend the aerial! wire as
Straight as possible and, while listening to
the sound from the system, secure it ina
position which yields minimal distortion
and noise.
AM Loop aerial
Assemble the loop aerial as shown in figure.
Unwind the aerial wires, then connect them
to the AM LOOP terminals. Place the loop
aerial in a position which yields the best
AM reception, or attach it to a wall or other
surface as shown in figure.