Sanyo DC-DA280 - REMOTE CONTROL; Remote Control Button Functions; GENERAL OPERATION; Powering On;Off and Function Selection

Desde tales Wade HMw eee eiie Hag Ea ne IGM eae N EOAHbG
Controls
REMOTE CONTROLLER RB-DAz80
k
. Number buttons (1-9, 0)
2. Cassette deck controls
O: Record muting button
@: Record/Record pause button
<<, >»: Fast forward/Rewind buttons
>: play button
E: Stop button
3. FM mode button (FM MODE)
4. CD player controls
>/t: Play/Pause button
E: Stop button
REPEAT: Repeat button
5. Memory button (MEMORY)
6. Sound preset button (SOUND PRESET)
7. Tuning buttons (TUNING +, -, a-s, >)
(These buttons can also be used as CD playing tracks skip and
search button)
8. Tuner function/Band select button (TUNER/BAND)
9. Volume buttons (VOLUME +, -)
10. Preset tuning button (PRESET)
11. Line function button (LINE)
__ GENERAL
Turning the power on and off
To turn the power on, press the power button and the display lights.
To turn the power off, press the power button again, the display goes out.
Selecting the function
Press the FUNCTION button to select the desired function as follows
display shows.
Cd —~ TAPE — TU — LInE — Cd —— ...
The function is automatically selected when CD play or type playback is
started or when the TUNER/BAND button has been pressed (except
during recording).
- When the function selection is changed, CD play or tape playback is
automatically stopped.
Adjusting the volume
Turn the VOLUME control, {or press the + or - VOLUME button on the
remote control). The volume level appears on the display. (VOL 0 ~ VOL
40)
REMOTE CONTRO
OPERATIO
Number buttons (1-9, 0)
These buttons are used to select the track numbers on a disc or preset
radio stations.
If the function is “CD”, the buttons select the track numbers on a disc.
lf the function is “TUNER”, the buttons select preset radio stations.
With any other function, the buttons will not function.
- Two buttons must always be pressed.
Example:
To select No. 3, press Q, then 3.
To select No. 10, press 1, then 0.
To select No. 25, press 2, then 5.
Inserting batteries
1 2
Two R03/HP16 batteries
Note:
(not
supplied)
Always remove batteries if the remote control is not to be used for a
month or more. Batteries left in the unit may leak and cause damage.
Remote control range
Remote sensor
Within approx.
7 meters
Surround sound button
Press the SURROUND button, “SURF” appears on the display and a 3
dimensional sound effect is created.
Bass expander button
Press the BASS button to enhance the bass sound.
“BASS” appears on the display.
Selecting the sound mode
Press the SOUND PRESET button to select the sound mode matching
the music to be listened to.
POP: Pops, etc.
ROCK: Rock music, etc.
JAZZ: Jazz, etc.
CLASSIC: Classical music, etc.
WHAT TO DO IF...
If the operation of the unit or display is not normal,
1. Disconnect the mains lead.
2. Press the CD button on the unit for at least 30 seconds.
3. Connect the mains lead.
4. Operate the unit.