6.
7.
8.
9.
Select the vohsxne level using the JOG DIAL control.
0-1 -2-3 -4-5 -6-7 -0-...
(or in the reverse sequence)
To check the actual sound level, it is recommended that the timer
be sat onossmdthe level heard. This can be checked by setting the
timer 2 mimutes later than the present time.
- If selecting the “O” level, the sound will be heard at the previous
VOLUME control setting.
Press the MEMORY button.
The original display returns, then the wake-up standby mode is
activated. ‘WAKE UP” remains lit.
Prepare
the scwrces to be used.
Press the POWER button to switch off the power.
Press the POWER button to switch off the power after the power is
turned on at the wake-up time.
Even after the WAKE UP timer operation has completed, “WAKE UP”
remains lit and the standby mode continues.
To check the timer settings
Press the WAKE UP button repeatedly. The timer settings are displayed
in the following occfec
Wake-up time
Source (If the tuner is being used as the source, the band, preset
number and frequency are displayed.)
Volume level
Original dispfq returns.
To change the s~-ngs, press the WAKE UP button to select the setting to
be changed, then press the MEMORY button so that the display blinks.
Change the
settingas explained above.
To release the WAKE UP timer
Press the WAKE UP button, then press the SET/CLEAR button. “WAKE
UP” disappears.
USING THE SLEEP TIMER
This timer automatically switches off the power after a preset time has
elapsed. The volume will gradually be reduced (fade-out) during the 1-
minute period before the unit turns off. There are 12 time periods
available: 120, 110,
100, 90, 80, 70, 80, 50, 40, 30, 20 and 10 minutes.
1.
2.
3.
Press the SLEEP button.
The previous sleep time setting blinks.
Press the SLEEP button within 5 seconds to select the desired sleep
time.
120- 110-...
20-10- (released) -120 -.. .
If the W/CLEAR button is pressed, the original display returns
and the SLEEP timer setting mode is released.
Allow 5 seconds to elapse or press the MEMORY button.
The original display returns and the SLEEP timer starts. The display
becomes dark slightly. “SLEEP” remains lit.
To check the remaining sleep time
Press the SLEEP button. After several seconds, the original display
returns.
To release the SLEEP timer while in operation
Press the SLEEP button, then press S~/CLEAR. The timer is also
released if the power is switched off.
Timer priorities
The ON/OFF timer settings are released ifthe actual time reaches the
ON time setting during WAKE UP timer operation.
During ON/OFF timer operation, the WAKE UP timer will not operate,
but the WAKE UP timer setting is retained.
The SLEEP timer has priority over the ON/OFF and WAKE UP timers.
The power is switched off by the SLEEP timer. The ON/OFF timer
seti-ng is released; but the WAKE UP timer setting is retained.
MAINTENANCE
Cleaning the deck head (Fig. 16)
To ensure playback and recording with good-quality sound, use cotton
swab to clean the head, pinch rollers and capstans of the deck after about
every 10 hours of use.
If the dirt persists, soak the swab in a little methylated spirit or head
cleaning fluid and then clean.
Main unit
Use a soft cloth to remove dirt on the main unit.
If the dirt persists, dip a soft cloth into a diluted solution of neutral
detergent, wring it out, wipe away the dirt, and then take up any moisture
with
a dry cloth.
Do not use benzene, thinners or alcohol since they will mar the finish of
the surfaces.
To Next Page
Loading...
Need help?
General
