Sanyo FVM4612 - Page 13

13
Need help? www.sanyoctv.com 1-800-877-5032
3. Selectthetuningband:Antennafor
externalantenna,Cableforcablesystem,
orthroughyourSet Top Box.
Setup Wizard (3/6)
Please select TV RF tuning band
Move Select
Antenna
Cable
Set Top Box
Previous Cancel
ENTER
4. Press[ENTER]buttontostartthechannel
scan.
Setup Wizard (4/6)
Please check that the RF cable is connected properly.
Scan time may take over 20 minutes.
Move Select
START
Previous Cancel
ENTER
5. Thechannelscanningisnowinprocess.
TheSetupWizardshowsthescanning
processofdigitalchannelsfirst,andthen
theanalogchannelsnext.
Thescanningprocesswillshowhow
manychannelsintotalhavebeenfound.
Pleasewaitwhilethescanningprocessis
searchingfortheavailablechannelsinyour
area.
Tocanceltheprocess,press[ENTER]
buttonontheremotecontrol.
Setup Wizard (5/6)
Searching CH
Digital Channels Found
Analog Channels Found
Channel 4
8
8
Searching. Please wait
Select
Cancel
50%
ENTER
NOTE:
• OnceyoucanceltheSetupWizard,itwillnotbe
shownagain.
6. TheSetup Wizardisdonenow.Youmay
press[EXIT]buttonontheremotecontrolto
tunetothefirstdetectedchannelrightaway.
Setup Wizard (6/6)
Congratulations. TV Setup is done.
Exit EXIT
NOTE:
• TheSetup Wizardwillnotappearagainonceyou
havecompleted.Forupdatingoraddingchannels,
refertotheAdd/Skip Channels featureonpage15.