3 Use your TV
Switching on your TV and putting it in
standby mode
TV
Remote control
To turn the TV on from standby or off to standby
●
Press
B
on the unit or the remote control.
Note(s)
●
Energy
consumption
contributes
to air and water pollution. When the AC power
cord is plugged in, your TV consumes energy with a very low standby power
consumption.
Adjusting volume
To decrease or increase volume
●
Press VOL + / – on the remote control.
VOL + : Volume up
VOL – : Volume down
To mute or unmute sound
●
Press
D
on the remote control to mute the sound.
●
Press
D
again or VOL + / – to recover the original sound.
Switching channels
To select channels by using CH + / –
●
Press CH + / – on the remote control.
To select channels by using the NUMBER keys
Digital TV operation
●
For digital channels,
press a number followed by a dot “•” and the
corresponding sub channel number.
–
When selecting digital channel 11.1
Be sure to press • before entering the subchannel number.
Cable / NTSC (Analog) TV operation
–
When selecting cable or analog channel 11
Press PREV.CH to return to the previously viewed channel.
Note(s)
●
To select the non-memorized channels, use the NUMBER keys.
●
No signal will
appear on
the TV screen after the subchannel broadcast is over.
●
Audio only program message will appear on the TV screen, when you receive
only a sound signal.
16 .English
Continued on next page.
To Next Page
Loading...
Need help?
General
