Sound
Before you begin:
You must set Home in Location. L p. 30
Otherwise, personalized picture and sound settings will not be
memorized after the unit goes into standby mode.
1
Press MENU and use
H
I
to select Sound, then press OK.
USB
Language
Features
Setup
Sound
Picture
Stereo
On
Off
On
Standard
Primary MTS
Digital output format
TV speakers
Auto volume leveling
Virtual surround sound
Equalizer
Auto sound
Bitstream
2
Use
H
I
J
K
to select the item you want to adjust, then press
OK.
Auto sound
To select the desired setting, then press OK.
(Personal, Standard, Vivid, Sports, Movie,
Music or News)
When you adjust the following settings
(Equalizer, Virtual surround sound or Auto
volume leveling), Personal sound will be set
automatically when Location is set to Home.
Adjust the tonal quality for each frequency.
Equalizer
Cursor
I
Cursor
H
To adjust each level of tonal quality.
Press BACK to go back to the previous menu.
Virtual surround sound gives you the stereophonic virtual space through
your existing 2-channel stereo system.
Virtual surround
sound
Off
Natural effect
On
Emphasized effect
This function keeps a constant loudness level between the TV
commercials and the programs.
Auto volume
leveling
Off
To remove the Auto volume
leveling
On
To reduce volume differences
between the TV commercials and
the programs
You can select the audio output from the unit’s speakers or not. If your
amplifier is HDMI link function compatible and connected by an HDMI
cable to this unit, some sound operations such as volume up can be
changed by using this unit’s remote control.
TV speakers
On
To output sound from the unit’s
speakers
Off
No output sound from the unit’s
speakers
fun-Link
To control audio output from your
connected fun-Link (HDMI CEC)
compliant devices with VOL + / –
by using this unit's remote
control.
You can select audio output through a digital audio output connector.
Digital output
format
Bitstream
To output Bitstream signals
(When the audio of the content is
PCM, it will be output in PCM even
if Bitstream is selected.)
PCM
To output PCM format
You can set the output mode as a default for the sound mode (Analog
TV only).
This setting is not interlocked when you change the output mode by
pressing SAP. Refer to Switching audio mode L p. 17.
Primary MTS
Stereo
To output stereo audio
Mono
To output mono audio
SAP
To output second audio program
Note(s)
●
When Digital output format is configured for Bitstream output while content with
Bitstream audio is being played, Voice guide ( L p. 24) is not contained in the
output.
22 .English
Continued on next page.
To Next Page
Loading...
Need help?
General
