Sanyo FWSB426F User Manual

–
11
–
EN
USING YOUR SOUNDBAR
Turning On the Soundbar
1
Press on the Remote Control.
2
Check that the LED indicator on the rear of the Subwoofer steadily lights up.
• The LED lights up if the Subwoofer is properly connected to the Soundbar.
Rear of Subwoofer
R
R
ear o
f
Subwoo
f
er
LED
CONNECT button
If the Soundbar is not Connecting to the Subwoofer:
1. Make sure the Subwoofer is connected to an AC outlet.
2. Press and Hold the CONNECT button on the Rear of the Subwoofer until the Red LED starts blinking rapidly.
3. Using the Remote Control, switch the Soundbar Input to AUX by pressing the AUX button.
4. Press and Hold the
PAIR button on the Remote Control until the AUX and BLUETOOTH LEDs on the Soundbar
blink together.
• The Soundbar is now attempting to Pair with the Subwoofer. The Red LED on the Rear of the Subwoofer will steadily
light up after the pairing success.
3
Select Input source.
LINE USB
INPUT
AUX PAIR
OPTICAL/
COAXIAL
e.g.) When was pressed the OPTICAL INPUT
(Orange LED) was selected. If the was
pressed again the COAXIAL INPUT (Green LED)
was selected.
• One of the INPUT indicators will light up when you switch to your Connected Source.
• For Bluetooth connections, refer to “Playing back a music file through Bluetooth” on page 15.

Sanyo FWSB426F Specifications

General

Style	Wireless Soundbar
Color	Black
Channels	2.1
Total Power	-
Speaker Units	Front: 30W x 2
Internal Memory	-
Radio Tuner	-
Wireless Connectivity	Bluetooth 4.2
Interface Connectors	USB Host 2.0
Sound Modes	Night Mode)
Max Sound Pressure Level (SPL)	-
Signal to Noise Ratio	-
Frequency Response	-
Features	Sound Share
Audio Processing	-
Water / Dust resistance	-
Power Supply	-
Power Consumption	Subwoofer 17 W
Battery Life	-
Battery Capacity	-

Weight and Dimensions

Depth	3.1 in
Height	3.1 in
Width	39.3 in
Net Weight	5.31 lbs