Sanyo FWSB426F - Choosing Preset Sound; Night Mode

–
14
–
EN
Choosing Preset Sound
1
Press either , , , , or on the Remote Control to select the desired
preset sound suitable for the Audio that is playing.
2
The LED in the center (OPTICAL/COAXIAL) blinks yellow once.
3
When the preset sound setting is set, LED indicators go back to the current Input.
NOTE(S)
• Select any Preset Sound according to your preference, regardless of categories.
• The default Preset Sound is MOVIE.
• This setting will remain while the Soundbar is in Standby mode.
Night Mode
Night Mode 1
Turns down the Volume on the Subwoofer. It is useful late at night.
1
To switch the unit to Night Mode 1, press .
Night Mode 2* (Dynamic Range Control)
Adjusts for clarity even when the Volume is Low, by compressing the range of the lowest sound level and the highest sound level.
1
To switch the unit to Night Mode 2, press and hold .
* This function is only effective for Dolby Digital sounds.
* This function is only available when the Soundbar is connected via Optical or Coaxial.
Mode LED lighting patterns LED behavior Sound effects
Night Mode 1
AUX PAIR
LINE USB OPTICAL/
COAXIAL
US
B
OPTICAL
/
C
OAXIA
L
AU
X
On: Flashes 4 times
Off:
Flashes twice
On: Lowers the Volume of the Subwoofer.
Off: Outputs the Sound at the same Volume
as the original.
Night Mode 2
AUX PAIR
LINE USB OPTICAL/
COAXIAL
US
B
OPTICAL
/
COAXIA
L
AU
X
On: Flashes 4 times
Off:
Flashes twice
On: Turns down loud sounds and turns up
soft sounds in order to keep voices at a
comfortable Volume.
Off: Outputs the Sound at the same Volume
as the original.
Input Source Night Mode 1 Night Mode 2
OPTICAL/COAXIAL
Dolby Digital
✔✔
PCM
✔
―
LINE
✔
―
AUX
✔
―
USB
✔
―
BLUETOOTH
✔
―
NOTE(S)
• The Default setting of both Night Modes is Off.
• These Settings will remain while the Soundbar is in Standby mode, so again use
to turn the mode from
current mode to the next mode.